Updated November 2026

Baby proofing phone chargers means keeping cords, plugs and charging bricks out of a toddler’s reach so they can’t pull, chew or insert anything into an outlet. Done well, it takes about an hour across your home and removes one of the most common electrical hazards in toddler households. This guide walks through where chargers tend to end up, what to change, and how to check your work.

Why Phone Chargers Are a Hazard

Toddlers are drawn to cords that dangle from counters and nightstands. A charging cable can be pulled off a surface, wrapped around a neck or chewed, and a loose plug can be poked into an open socket. Charging bricks also get hot during use, so a child who grabs one may be burned. Treat every charger as something a child will try to reach, because eventually one will.

Shopping for one? See our guide: 5 Best Buy Buy Baby Child Proofing Products for Cabinets and Drawers (2026).

Step 1: Map Every Charging Spot

Walk through the house and note every place a charger is plugged in. Include the kitchen counter, bedside tables, the living room sofa end table, the home office and any hallway outlet near a bench. Pay attention to outlets at toddler height, since those are the ones a child can reach without climbing. Write the list down so you can check each spot once you’ve finished.

Step 2: Move Chargers Out of Reach

The simplest fix is relocation. Plug chargers into outlets at least 48 inches above the floor, or use a higher surface such as a tall shelf, a wall-mounted cabinet or the top of a dresser. Keep the cord short enough that it can’t hang down to a child who is standing. Avoid running cords across walkways, under rugs or behind furniture where they can be tugged.

Step 3: Secure the Outlets and Cords

Once a charger is in its new spot, protect the outlet itself. Install tamper-resistant outlet covers or sliding plug covers on any receptacle a child can reach, and use cord shorteners or cable clips to keep excess cord from dangling. For the full set of options, see Plug Covers Baby Proofing: A Step-by-Step Guide for Every Room, which covers how each type fits different outlet styles.

Step 4: Choose Safer Charging Accessories

Look for chargers and cables with strain relief at the plug, since these hold up better when pulled. Short cables reduce the length a child can grab. Wireless charging pads that sit flat on a counter can remove the cord entirely from some spots, though they still need to be out of reach if they plug into a wall. Keep chargers in a drawer or caddy when not in use.

Step 5: Check Each Room Again

Before you call it finished, do a sweep at toddler eye level. Crouch down and look for cords, exposed plugs and any outlet left uncovered. Try reaching for each charger from a child’s height and from a step stool, since toddlers climb. Repeat the check whenever you add furniture or change where you charge devices, because new spots often appear without notice.

Step 6: Build a Quick Routine

Make charging a habit that stays safe. Plug devices in at a designated counter or shelf, unplug them when charged, and return cables to their holder. Teach older toddlers that cords and chargers are not toys. Revisit your map every few months, especially after visitors, moves or new gadgets enter the house.

Common Mistakes

  • Leaving a charger on the floor beside a bed or couch, where a crawling child can reach it.
  • Using a long extension cord to power a charging station that a toddler can access.
  • Covering an outlet with furniture while the plug stays partly exposed.
  • Assuming a wireless pad is safe when its power brick still sits on the floor.
  • Skipping the eye-level check after rearranging a room.
  • Tamper-resistant outlet covers block access to unused sockets and are a practical first step in any room. View on Amazon
  • Cable clips and cord shorteners keep excess cord tight against the wall or furniture so it can’t dangle. View on Amazon
  • Wall-mounted charging station lifts devices and cords out of reach while keeping charging in one tidy place. View on Amazon

FAQ

How high should a phone charger be to keep it away from toddlers?

Aim for at least 48 inches above the floor, and make sure the cord cannot hang down within reach. Remember that toddlers climb, so check the spot from a step stool as well as from floor level.

Are wireless chargers safer than cable chargers?

They can reduce loose cords, but the charging pad and its power brick still need to be out of reach. Treat the whole setup as you would any other electrical device.

Do I need to call an electrician for outlet covers?

Plug-in and tamper-resistant covers are generally a do-it-yourself job. If an outlet looks damaged, feels warm or doesn’t work properly, consult a licensed electrician before doing anything else.

Conclusion

Baby proofing phone chargers comes down to mapping every spot, moving devices out of reach, and securing outlets and cords. Repeat the eye-level check after changes in your home. For a wider view of your home, see Safety Proofing Home for Baby Checklist: 12 Room-by-Room Steps.

Graham Fisher

About Graham Fisher

Graham Fisher is part of our editorial team and reviews and edits our childproofing guides, checking product details against manufacturer specifications and owner feedback.