Updated November 2026

Jambini magnetic cabinet locks are a hidden-style childproofing option that uses a magnetic key piece to release a catch on the inside of a cabinet door. This guide walks you through checking your cabinets, placing the lock, and testing that it holds, so a toddler can’t pull the door open and reach what’s inside.

Check Your Cabinets Before You Buy or Install

Magnetic locks depend on the cabinet structure, so start by inspecting what you have. Open each door and look at the inside face, the frame, and the hinge side. You want a flat, solid surface at least about one-half inch thick where the catch will sit. Thin particleboard or a door with a heavy overlay can flex and let the catch slip.

Shopping for one? See our guide: Magnetic Locks for Cabinet: 6 Best Picks Compared (2026).

Also confirm the cabinet opens by pulling outward from a handle or knob, not by a push latch. Push-latch doors often need a different kind of lock. Check the manufacturer’s listed door thickness and mounting surface before you commit to a set.

Install the Lock Step by Step

Most magnetic systems follow the same sequence. Read the instructions that come with your specific kit, since spacing and adhesive requirements vary by model.

  1. Clean the inside of the door and the frame with rubbing alcohol and let them dry fully.
  2. Close the door and mark the catch position on the frame using the template or the included magnet piece.
  3. Attach the catch or sensor to the door interior and the matching magnet or release piece to the frame, keeping both aligned with the closed-door edge.
  4. Press firmly for the number of seconds the adhesive requires, then wait the full cure time before loading the cabinet.
  5. Test the lock with the magnetic key and confirm the door releases smoothly.

If you use screws instead of adhesive, pre-drill to avoid splitting the wood. Adhesive mounts are easier to remove later but need a clean, dry surface to hold.

Test the Lock Before You Trust It

A lock that looks installed may not hold under real force. Run three checks after the adhesive or screws have cured. First, close the door and try to open it by pulling on the handle with a firm, steady tug. Second, try a quick yank, since toddlers tend to pull in bursts. Third, open and close the door ten or so times to make sure the catch still lines up and doesn’t drift.

If the door opens during any test, reposition the catch closer to the center of the door edge or add a second catch on a higher or lower point. Recheck once the new placement cures.

Common Mistakes to Avoid

  • Installing on a door that flexes or has a thin laminate surface, which lets the catch pop free.
  • Skipping the alcohol cleaning, which leaves dust that weakens adhesive.
  • Loading the cabinet before the adhesive finishes curing.
  • Leaving the magnetic key where a child can find it, or keeping spare keys in the kitchen.
  • Assuming one lock covers every cabinet. Test each door separately.

FAQ

Do jambini magnetic cabinet locks work on all cabinet types?

They work best on flat-fronted doors that open outward with a handle. Push-latch doors and very thin doors often need a different lock type.

How do I remove the lock without damaging the cabinet?

For adhesive mounts, warm the pad with a hair dryer on low to soften the bond, then peel slowly. Follow the removal steps in the kit instructions.

Is a magnetic lock enough to childproof a cabinet on its own?

It is one layer of protection. Store medications, cleaners, and small objects out of reach as well, and consult your pediatrician or a poison control resource for guidance on high-risk items.

Conclusion

With the right surface, careful cleaning, and a full cure time, a magnetic lock can keep a toddler out of a cabinet while you still reach it easily. Test every door under real pulling force before you rely on it. Recheck placement after a few weeks, since adhesive and wear can change how the catch holds.

Ethan Brooks

About Ethan Brooks

Ethan Brooks is part of our editorial team and reviews and edits our childproofing guides, checking product details against manufacturer specifications and owner feedback.