Updated November 2026

Ground anchors for garden furniture hold tables, chairs, umbrellas and benches in place by fixing them to the soil with a metal stake and tether or bracket. This guide explains how to choose the right type, install it correctly and check that it still holds after a season of weather. Most of the work takes an afternoon, and the result is furniture that stays put when a gust hits.

Choose the Right Type of Ground Anchor

Ground anchors come in a few main forms. Screw-in auger anchors have a spiral blade that you turn into the soil by hand or with a wrench. Driven spike anchors are hammered in and suit firm ground. Concrete-set anchors are cast into a footing and offer the most holding power but are permanent. For most patios and lawns, a screw-in or driven anchor is enough.

Shopping for one? See our guide: 7 Best Ace Hardware Furniture Anchors for Baby Proofing (2026).

Check the manufacturer’s rated load and match it to your furniture. A light folding chair needs far less holding force than a heavy umbrella base or a wooden bench.

Install the Anchors in the Right Position

Place anchors where the furniture’s own anchor points or legs line up, not in the middle of open ground. Keep each tether short enough that the furniture cannot slide far, but leave a little slack so the connection does not snap under load.

  1. Mark the anchor points on the ground using the furniture legs or a bracket.
  2. Clear grass, stones and roots at each spot so the anchor sits flush.
  3. Drive or screw the anchor straight down until the collar or head is level with the surface.
  4. Attach the tether or bracket and tighten it so the furniture sits firmly without lifting.
  5. Test each point by pulling sideways. Nothing should shift or lift noticeably.

Match the Anchor to Your Soil and Surface

Lawns and loose soil

Soft or wet soil gives less grip. Use a longer auger or add a second anchor per leg. Wait for the ground to dry before driving anything in, since saturated soil can let an anchor pull out.

Paving, decking and hard surfaces

Standard ground anchors will not fit into paving or stone. Use a surface-mounted base with masonry fixings, or choose a weighted or clamp-style option that does not need to penetrate the surface. Check with a professional before drilling into a deck or terrace, since you may affect its structure or drainage.

Check and Maintain Your Anchors

Inspect anchors at the start and end of each season. Look for rust, bent tethers, loose collars and soil that has eroded around the stake. Tighten or replace anything worn. Taking furniture in during severe storms also reduces the load on the anchors.

Common Mistakes

  • Installing anchors in soil that is still soggy from rain, which reduces holding power.
  • Using tethers with no slack, so the force of a gust transfers straight to the furniture frame.
  • Leaving anchor heads raised above the surface, where they can catch feet or mowers.
  • Assuming one anchor per piece is enough for tall umbrellas or lightweight plastic furniture.
  • Skipping seasonal checks, so rust or loosening goes unnoticed until a storm.

A sturdy mallet or driving tool helps seat driven anchors evenly without bending the stake. View on Amazon

Galvanized or stainless steel tethers resist rust better than plain steel when left outdoors. View on Amazon

A small spade or trowel makes clearing roots and stones at each anchor point much faster. View on Amazon

For a deeper look at anchoring methods used indoors, see Furniture Anchors: Stopping TV and Dresser Tip-Overs and Anchors for Outdoor Furniture: Stop Tip-Overs in 6 Steps.

FAQ

Can ground anchors damage my lawn?

Installing an anchor leaves a small hole and disturbs the turf around it. Re-level the soil and reseed or re-turf the spot once the anchor is removed for the season.

How deep should a ground anchor go?

Follow the manufacturer’s depth marking, which is usually stamped on the stake or shown in the instructions. The collar or head should sit level with the ground.

Are ground anchors safe to use with children around?

Keep anchor heads flush with the surface and avoid tethers that children could trip over. For specific safety questions about play areas, consult the manufacturer or a qualified professional.

Conclusion

Choosing the right anchor type, placing it at the furniture’s anchor points and checking it each season will keep garden furniture stable. Match the method to your soil or surface, and keep tethers slightly slack so the force of wind is spread evenly. A few minutes of testing after installation is the best way to confirm the setup will hold.

Ethan Brooks

About Ethan Brooks

Ethan Brooks is part of our editorial team and reviews and edits our childproofing guides, checking product details against manufacturer specifications and owner feedback.